Nightcore Daycore
About
- Username
- Nightcore Daycore
- Joined
- Visits
- 3,808
- Last Active
- Roles
- Member
Comments
-
For the Compressor, will you please change the High pass filter to a Hard and Soft Knee instead for the update too?
-
Will you also please add Expander in the components for the update?
-
Balance: Load and Save Preset
-
If some tracks splits do cut off within tracks of an album, the best option is to delete cut off track splits in Track Isolation Splitter. Depending on your desired number dB for headroom that you rely on when it comes to 60 Hz dB boosting without c…
-
Because the 2 lowest kbps Bitrate numbers I saw was 64 and 48 kbps.
-
Can you please also add 3 tracks as well in Track Isolation Splitter? Do you think that's possible too? Or no?
-
100% to 150% = +3.52 dB 150% to 200% = 7.04 dB 200% to 250% = 10.56 dB 250% to 300% = 14.08 dB 300% + 0.92 = 15 dB I was correct about this. Track Isolation Splitter update to 350% please.
-
To all the people that are using Track Isolation Splitter in Music Speed Changer, warning: Some tracks on an album in Track Isolation Splitter are going to stop/cut off due to the song's ending point. Even though the track split processing is comple…
-
12KHZ is the Hi-Fi frequency when it comes to air and sparkle as well, did you know that?
-
Or, do you think that the Encoding kbps Bitrate number basically affects audio quality and music? Is that what it's about?
-
That's why there's 4 numbers with more zeroes and I thought of it in order. It starts with 10 the very first double digit number after 9. And then 100, the very first triple digit number after 99. And then 1000, the very first quadruple digit number…
-
You can bass boost by boosting 60 Hz and 150 Hz together to bring out the bass. Until the 2025 update happens for Music Speed Changer, you will happily cut and remove 150 Hz and boost 20 Hz and 60 Hz together for sub bass boosting.
-
I also think of Track Isolation Splitter as a headroom fine tuner. You're basically pulling up the track splits to your desired headroom dB level to rely on preamp and EQ wise in general when it comes to music and audio.
-
Because 10 is the first double digit number after 9, 10 Hz is what humans obviously cannot hear. Then there's 100 Hz, which is the actual bass frequency. Then there's 1000 Hz, the censorship bleep tone. That's why I'm excited for the 10KHZ change in…
-
That means the maximum percentage of Track Isolation Splitter would be extended up to 350% instead for all track splits for the update of Music Speed Changer for 2025. As far as checking the dB headroom increase from 100% to 150% for all track split…
-
179 MB AI models is a lot for track splits in Track Isolation Splitter. Do you think you can lower it to 1 MB or 10 MB? Or, no it's not possible?
-
When you pull up a track split up to 150% maximum, the dB level is up to +3. 52dB of headroom depending on the level of the preamp of the track.
-
The reason why I said 250% and more because some parts headroom wise that aren't too low in the mix of the track, it can be pulled up in Track Isolation Splitter beyond 200% for some bass and vocals depending on the track headroom wise and dynamic r…
-
The reason why I thought of 3 equalizer frequencies is because: 1. 20 Hz is the lowest frequency of sub bass and starting point of human hearing. 2. 15KHz is the minimum beginning point of the high frequency hearing threshold limit of adults. 3. 10K…
-
What are AI models in Track Isolation Splitter?
-
Did you also know that normalizing audio, bass, instruments, and sounds is automatic volume leveling too? It automatically adjusts volume gain through a specific target dB level headroom wise and not the tone or anything else. Do you think you can a…
-
Sorry, I'm not trying to annoy you, harass you, irritate you, piss you off, get you mad/angry or anything like that. I do know how to be patient. But, I'm gonna be so excited for the 2025 update for Music Speed Changer this year for the new and addi…
-
I also forgot to ask for you to change the Compressor Release up to 5 maximum. And change the Limiter Release to either 1 or 2 maximum and 10 millisecond minimum. Including the Ceiling to -60 dB too as well.
-
And by "process", I'm talking like the time you're gonna be taking when it comes to updating Music Speed Changer in 2025 for the Feature Requests.
-
I also forgot to ask if you can also change the Track Isolation Splitter encoding kbps bitrate default number 320 down to 128 kbps instead to update the file format for all track splits for the update? Is it possible, or is there nothing that can be…
-
Do you think you can make the update happen for tomorrow and New Year's Eve 2024? Or, no?
-
I think you can do it, I believe in you. I'm assuming the update of the app is going to be easy. Maybe?
-
Do you agree with the 15KHz-17KHZ adult hearing threshold high frequency limit thing when it comes to aging and getting older?
-
Including 20 Hz. Sorry, not trying to harass you or anything about it.
-
As well as changing 8KHZ to 10KHZ too. Maybe, just maybe for the two updates for 2025. I may regret this, or not.
Howdy, Stranger!
It looks like you're new here. If you want to get involved, click one of these buttons!