Preamp

448 Hz · June 2022

I don't know if I'm doing this right or wrong. But, when I convert my favorite songs to 448 Hz, I lower the preamp to get rid of distortion as I do the loop as well. And then I activate the 448 Hz pure tone, I paste in 101.81% from most 440 Hz songs. And, then I tag edit the song after I hit save edited track. Then, I do the limiting in the Limiter. The threshold doesn't react until a little tiny bit of dB later, even though the limiting is doing the same exact thing from the default release. Am I supposed to use the preamp from the Limiter to let the ceiling stay at 0 dB as the threshold kicks in early from the original leveling of the distorted preamp and song in general? Or, no?

448 Hz · January 21

Can you please also put the load and save preset in the Preamp too as an update? Because when the Compressor is opened, it subtly clips from the default settings even when you reset the Compressor.

448 Hz · February 7

Including Balance too?

448 Hz · February 29

When I turn the Compressor on by default, I turn the preamp down to -2.1 dB as far as -15 dB of headroom goes. That's why I'm asking you for the official update of the Preamp and Balance to add the load and save preset.